Stator Gator Sensors
 Stator gator sensors are the easiest plug and play gov sensors on the market. These are a must have if you plan on installing a gov system like a CSM revlock etc. These make very low consistant rpms possible for an awesome sound with a 4 bladed head at 1100 rpm without overheating the motor!


How does the Stator Gator differ from others?
 The Stator Gator line of sensors are like no other sensors on the market. This sensor takes the raw signal from the kill switch wire, conditions and converts it into a useable signal for the GV-1, csm "gasser" revlock, or other similar types of rpm controllers.
There are no direct electrical connections between the engines ignition system and your radio system. The units are optically coupled ....meaning all conditioned signals are transmitted by light inside the unit.
There are no magnets to mount or sensors to adjust! Just plug N play.
Mounts with foam tape in a convenient location and the Futaba J connector is plugged into the sensor slot on your gov. Program your gov. and your done!



Which sensor do I need?

  • GGS-23
    $39.95

    GGS-23 sensor shown.
    The GGS-23 is designed for the PUH series of engines, including the new 231 PUH and the newer G26's, including Hanson modified engines, as used in Bergen, Century, JR and X-cell helicopters (including the Spectra-G). This unit connects to the black engine kill wire and an engine ground.





  • GGS-23RC
    $39.95
    GGS-23 sensor shown.
    GGS-23RC GV-1 sensor for 230RC series engines as used in Vario Helicopter's with a SQUARE kill switch
    This unit has an adaptor that replaces your stock kill switch. Note: You WILL lose you stock kill switch feature. Simply slide out your stock kill switch far enough to access the two spade connector's, disconnect them from the switch. Plug the red wire onto the adapter spade marked in red and plug the black wire onto the remaining spade. The adapter snaps back into the stock kill switch location. The GGS-23-RC mounts with foam tape in a convenient location and the Futaba J connector is plugged into the sensor slot on your gov. Program your gov and your done!


  • GGS-G2D
    $39.95
    GGS-23 sensor shown.
    This sensor is for use on early Vario helicopters with a ROUND kill switch.
    You will lose the kill switch function (can be custom wired by the owner to use the stock kill switch)